CERAKOTE® (Oven Cure) H-Series Coating- Ceramic Technology Performance + Color on All- Metals, Polymers+More - (Part B) Included (H-190 Armor Black,4oz Tester)

Considering H-Series? Check out our Starter Kits! Founded over 35 years ago, NIC Industries Inc.'s vision was to manufacture coating products that would truly have a global impact. NIC now manufactures industry-leading coatings that are distributed and sold in nearly 90 countries around the world. CERAKOTE ,PRISMATIC POWDERS ,and Performance Materials operate as separate divisions of NIC. NIC's customer base is as wide as its geographical impact, with applications in technology, aerospace, sporting goods, and the automotive industry. A relentless pursuit to provide market-leading coating technologies with an unyielding passion to never settle.

TIPS FOR SANDBLASTING REMEMBER: Always wear powder-free latex or nitrile gloves when handling parts. Avoid touching parts with your bare hands.

TIPS FOR RACKING SMALL PARTS Gas out will evaporate any remaining solvents from the degreasing phase while also drawing out any possible trapped oils or contaminants. Heat metal parts in a convection style oven at 300°F (149°C) for 60 minutes. CAUTION: Allow parts to cool to room temperature prior to re-degreasing.

Begin by agitating the Cerakote bottle until the coating has been mixed for 5-10 minutes. We recommend a paint shaker (Item SE-369) for pints, quarts, and gallons. For testers, agitating by hand is sufficient. TIP: Determine how much Cerakote you intend to use before adding catalyst Pot life for mixed Cerakote is approximately 1-2 hours in a sealed glass graduated cylinder, beaker or aluminum spray gun cup. IMPORTANT! : Do not mix Cerakote and catalyst in non compatible plastic containers, as this may compromise the integrity of the coating. MIXING PROPORTIONS: If proportions of Cerakote to catalyst are incorrect, or the combination of product and catalyst are not thoroughly mixed, the quality and performance of the coating will be affected. NOTE: All Cerakote bottle labels list the recommended strainer size. Pour coating through the appropriate mesh strainer into the spray gun cup.

PATTERN ADJUSTMENT KNOB FLUID ADJUSTMENT KNOB AIR ADJUSTMENT KNOB TESTING SPRAY GUN SETTINGS Practice spraying on an easel pad to adjust the spray pattern and to practice your spraying technique. Adjust the spray gun to achieve a 2-3” oval fan pattern, while spraying from a distance of 3-5”. For hard to reach areas, adjust your spray gun settings to achieve a 1” oval with moderate sized splatter. Blow off the parts with dry compressed air to make sure there is no trapped media in holes, seams or pockets. Strive for even coverage when spraying. The coating should appear wet but not so wet that the coating will run. Cerakote will be wet to the touch until is it oven cured. For H-Series, coating thickness will be