Injector Puller and Teflon Seal Installer Tools Set Fits for BMW N14 N18 N54 N63 Diesel Engines, Alternative to 130192, 130193, 130194 and 130195

Use the right tools set for the job, don't risk remove your fuel injectors. Improper methods will probably damage the seal, result in compression loss and oil or fuel consumption. The Teflon seals MUST be replaced while they are removed the from the cylinder head. If not, it's possible to damage the cylinder head and cost more! Application: Compatible with BMW N14, N18, N54 and N63 engine. Fits for 2007-2010 BMW 335i, 335xi, X5 3.0L. Fits for 2008-2010 BMW 135is, 535i, 535xi, X5 3.0. Fits for 2009-2013 BMW 750i, 750Li. Fits for 2010-2013 BMW 550i GT. Fits for 2011-2013 BMW X5. Fits for 2007-2012 Mini Cooper N14 engine. Powerful Functions: Comparable for BMW Tools 130192, 130193, 130194 and 130195. Used to easily & quickly pull injectors without damage, and this set comes with necessary tools for installing replacement injector Teflon seals smoothly and efficiently. Step 1. Assemble the tool, and screw the adapter on to the top of the injector; Step 2. Matter upper & lower motion to pull the sliding hammer repeat; Step 3. Pull out the whole tool and injector. Step 4. Removal Finished. Step 1. Remove old Teflon sealing ring with special tool (Not includes) from injector; Step 2. Slide new Teflon sealing ring onto mounting assembly cone, then mount it onto injector tip; Step 3. Push Teflon sealing ring into injector groove with installer (Not fingernails); Step 4. Calibration sleeve is placed over the seal to compress it back to the correct outer diameter to allow installation into the cylinder head.